1 ct small Clip ‘N Turn for 3/8 inch to 1 inch (0.95 cm to 2.54 cm) fabric tubes
1 ct large Clip ‘N Turn for 3/4 inch (1.9 cm) or larger fabric tubes
Stitch fabric tube, leaving both ends opened; trim seams.
Insert pointed end of Clip ‘N Turn (logo side up) into end of fabric tube. Bend turner slightly to allow clip to slide over top of fabric.
Slide fabric onto Clip ‘N Turn until end is at bottom of clip. Press clip down until it locks.
Slowly fold fabric tube down over clip. Once tube is over clip, push all of the fabric tube onto Clip ‘N Turn, gathering as you go. TIP: It is easier to turn tube if all of the fabric is gathered onto the turner.
Hold pointed end of Clip ‘N Turn and pull gathered fabric tube off turner.
To remove the Clip ‘N Turn, push clip from back to release. Push turner back into tube slightly to release fabric from clip. Use turner end to push out remainder of fabric tube.
To insert cording in tube, thread cording through eye in Clip ‘N Turn before turning fabric tube.
For thick cording, turn fabric tube first. Tape or tie string around cording end and secure to clip on Clip ‘N Turn. Thread through fabric tube.